Please use this identifier to cite or link to this item:
Full metadata record
DC FieldValueLanguage
dc.contributor.authorArya, Suneeta-
dc.contributor.authorSharma, S M-
dc.contributor.authorSharma, R K-
dc.contributor.authorSrivastava, V-
dc.contributor.authorBindal, V K-
dc.contributor.authorPaul, A K-
dc.identifier.issn0975-2412 (Online); 0771-7706 (Print)-
dc.description.abstractThere are chances of reflections of unwanted signal, due to several unavoidable reasons, in any working microwave tube. Due to this, the tubes do not give the desired performance. To minimise the chances of reflections the attenuators are used in microwave tubes. These attenuators may be used either inside or outside the tube depending upon its end use. For the fabrication of the attenuators in helix TWTs, the support rods are coated with controlled carbon layer with the specific profile and length using the specific processes. In this paper process of carbon coating on support rods using RF sputtering technique has been described in detail.en_US
dc.publisherNISCAIR-CSIR, Indiaen_US
dc.rightsCC Attribution-Noncommercial-No Derivative Works 2.5 Indiaen_US
dc.sourceBVAAP Vol.20(2) [December 2012]en_US
dc.titleDevelopment of attenuators by carbon coating on APBN support rods using RF sputtering techniquesen_US
Appears in Collections:BVAAP Vol.20(2) [December 2012]

Files in This Item:
File Description SizeFormat 
BVAAP 20(2) 221-224.pdf167.41 kBAdobe PDFView/Open

Items in NOPR are protected by copyright, with all rights reserved, unless otherwise indicated.