Please use this identifier to cite or link to this item: http://nopr.niscpr.res.in/handle/123456789/30404
Full metadata record
DC FieldValueLanguage
dc.contributor.authorGaitonde, V N-
dc.contributor.authorAchyutha, B T-
dc.contributor.authorSiddeswarappa, B-
dc.date.accessioned2015-01-19T05:49:41Z-
dc.date.available2015-01-19T05:49:41Z-
dc.date.issued2005-04-
dc.identifier.issn0975-1017 (Online); 0971-4588 (Print)-
dc.identifier.urihttp://hdl.handle.net/123456789/30404-
dc.description91-96en_US
dc.description.abstractBurr formation in drilling is one of the serious problems in precision engineering and mass production. The exit burr degrades the precision of products and causes additional cost of deburring. Since deburring processes are not yet well automated, the productivity of advanced manufacturing systems is often reduced. However, these processes are labour intensive and add to the total cost of components. Therefore, understanding the drilling burr formation and its dominant parameters is essential for controlling the burr size. This paper describes the Taguchi method based robust design philosophy for minimization of burr size- in drilling. Four parameters, namely, cutting speed, feed rate, point angle and clearance angle were identified and the ranges of the parameters for the present investigation was determined from preliminary experiments. Each parameter was investigated at three levels to study the non-linearity effect of the parameters. Taguchi method based L9 orthogonal array was selected and experiments were conducted as per experimental layout plan. Based on signal to noise ratio analysis, the optimal settings of the process parameters have been determined. Confirmation tests have also been performed to predict and verify the adequacy of the additive models for determining the optimal burr size. en_US
dc.language.isoen_USen_US
dc.publisherNISCAIR-CSIR, Indiaen_US
dc.relation.ispartofseriesB23B 51/00en_US
dc.rights CC Attribution-Noncommercial-No Derivative Works 2.5 Indiaen_US
dc.sourceIJEMS Vol.12(2) [April 2005]en_US
dc.titleBurr size minimization in drilling using Taguchi techniqueen_US
dc.typeArticleen_US
Appears in Collections:IJEMS Vol.12(2) [April 2005]

Files in This Item:
File Description SizeFormat 
IJEMS 12(2) 91-96.pdf1.32 MBAdobe PDFView/Open


Items in NOPR are protected by copyright, with all rights reserved, unless otherwise indicated.